Deny-by-default
Deny-by-default is an authorization technique in which access is denied unless an applicable access-control rule explicitly permits it.
Acing the CCNA Exam: Volume 1 Fundamentals and Protocols
An implicit deny is a hidden access-control rule that denies traffic matching none of an access control list's explicit conditions.
- How it is used
- Secures ACL filtering by rejecting traffic that no explicit ACE permits.
- How deep it goes
- Defines the hidden rule and traces sequential ACE evaluation, without covering command syntax.
- Examples
- Uses overlapping private networks and a 172.16.1.1 packet to demonstrate rule order and unmatched denial.
- What you can do after
- Evaluate ACL behavior and identify why unmatched packets are discarded.
Read how Acing the CCNA Exam: Volume 1 Fundamentals and Protocols explains deny-by-default →
Grokking Software Architecture
Deny by default is a security policy in which access is rejected unless it is explicitly permitted.
- How it is used
- Migrates legacy network traffic toward Zero Trust by tightening service access after observing existing communication.
- How deep it goes
- Defines the access policy and outlines migration stages, but does not show policy syntax.
- Examples
- Uses a legacy application's observed network traffic to establish which service connections to permit.
- What you can do after
- Configure service-mesh policies gradually, moving from observed legacy traffic to explicitly permitted connections.
Read how Grokking Software Architecture explains deny-by-default →
Also covered in
Related concepts
- access control listpart of · An access control list is a set of rules or permissions specifying which identities or network traffic may access a resource or perform particular operations.
- deny-overridesproduced by · Deny-overrides is a policy-combining rule in which any applicable deny result takes precedence over permit results.
- extended access control listpart of · An extended access control list is an access control list that filters packets using multiple packet attributes, including Layer 4 protocols, source and destination IP addresses, and source and destination ports.
- permit policycontrasts with · A permit policy is an authorization policy whose applicable true evaluation grants access unless an overriding forbid policy applies.
- network packetconfigures · A network packet is a formatted unit of data transmitted across a computer network.
Questions about deny-by-default
What is deny-by-default?
Deny-by-default is an authorization technique in which access is denied unless an applicable access-control rule explicitly permits it.
Which Manning books explain deny-by-default?
Acing the CCNA Exam: Volume 1 Fundamentals and Protocols and Grokking Software Architecture.
What is the difference between deny-by-default and permit policy?
Deny-by-default is an authorization technique in which access is denied unless an applicable access-control rule explicitly permits it. A permit policy is an authorization policy whose applicable true evaluation grants access unless an overriding forbid policy applies.
What is deny-by-default part of?
Deny-by-default is part of access control list. An access control list is a set of rules or permissions specifying which identities or network traffic may access a resource or perform particular operations.
What is deny-by-default also called?
Deny-by-default is also called implicit deny.
These guides are generated from the text of Manning books by Manning's knowledge graph and link to the sections they draw on. The full books are available on liveBook and at manning.com.

