liveBook · Manning

Initial stack pointer

As explained in Embedded Software with Rust

The initial stack pointer is the stack address loaded by a processor when it begins executing an image.

The initial stack pointer is the stack address loaded by the processor when it starts an image. On Arm Cortex-M, the first vector table entry supplies the initial value of the Main Stack Pointer (MSP); the second entry gives the reset handler address. The first entry is an address, not a function pointer. section 4.1.3 section 4.2.1

A linker script can place the vector table in FLASH and compute the initial stack pointer as the end of RAM. The stack then grows downward. This does not reserve a separate stack section: enough RAM must remain unused, or the stack and other data can overwrite each other. section 4.1.3

SECTIONS
{
  .vector_table :
  {
    LONG(ORIGIN(RAM) + LENGTH(RAM));     /* Initial stack pointer (
        top of RAM) */
    KEEP(*(.vector_table.reset_vector))   /* Reset vector (
        entry point) */
    KEEP(*(.vector_table.exceptions))     /* Other exceptions and
    interrupts */
  } > FLASH

The LONG expression writes the initial stack pointer as the first entry. KEEP preserves the reset vector and exception entries during linker garbage collection. section 4.1.3

At startup, the processor looks for the vector table at address 0x00000000. A device can alias that address to FLASH at a higher address, such as 0x08000000. After loading the MSP and jumping to the reset handler, low-level initialization begins. section 4.2.1

Check the initial MSP value, reset handler, NMI handler, and hard fault handler carefully. Missing, misaligned, or incorrect entries can prevent booting or cause unpredictable behavior. For common single-image firmware, runtime crates such as cortex-m-rt can provide the startup setup; a custom linker script can control memory regions and section placement. section 4.2.4 section 1.3.3

How Embedded Software with Rust covers it

How deep it goes
Explains the linker calculation, downward stack growth, and collision risk, alongside processor loading of the MSP.
Examples
Shows a linker script that writes the end of RAM into a FLASH vector table and preserves handler entries.
What you can do after
Operate/configure a linker script to place the initial stack pointer and check critical vector entries for boot failures.
How it connects
Connects the stack pointer to the vector table, reset handler, linker script, and memory mapping.

Related concepts

This explainer was generated by Manning's knowledge graph from the text of Embedded Software with Rust. The section links point to the parts of the book it draws on.