liveBook · Manning

Main stack pointer

As explained in Embedded Software with Rust

MSP is the Cortex-M Main Stack Pointer system register holding the active main-stack address.

The main stack pointer (MSP) holds the active main-stack address. On reset, a Cortex-M processor loads its initial value from the first vector-table entry, then loads the reset-handler address from the second and transfers control to it. section 1.2.1 section 4.2.1

Treat the initial MSP entry as essential startup configuration:

  • It is a RAM address marking the start of the stack region, not a function pointer. An absent, misaligned, or incorrect entry can prevent boot or cause unpredictable behavior. section 4.2.4
Figure 4.3 MCU boot sequence
CH04 F03 Cabanis

The MCU boot-sequence figure helps locate MSP initialization within reset startup. section 4.2.1

How Embedded Software with Rust covers it

How deep it goes
Defines the MSP as a RAM stack address and explains its vector-table loading, but does not detail stack operation afterward.
Examples
Uses the first vector-table entry and reset sequence to illustrate MSP initialization.
What you can do after
Configure and verify the initial MSP vector-table entry as a valid RAM stack address to reduce the risk of boot failure.
How it connects
Links the MSP to the vector table, reset handler, RAM, and Cortex-M startup.

Related concepts

This explainer was generated by Manning's knowledge graph from the text of Embedded Software with Rust. The section links point to the parts of the book it draws on.